Some simple rules will smooth things

Article Index
Some simple rules will smooth things
Rule 4: Open-coat abrasives avoid clogging
All Pages

Experienced shop managers know that productivity is harmed not by catastrophe, but often by common errors. For example, a worker who bears down on a sander is not only working himself too hard, he may very well be damaging the equipment. Fortunately, breakdowns and inferior results can be avoided — and profits can be increased — if everyone in the shop heeds the five rules for saving men and machines.

The five rules don’t require equipment upgrades, large expenditures of capital or woodworking genius. But a little common sense and cooperation among management and staff can significantly improve productivity and morale.

Rule 1: Air orbital sanders require a consistent air supply
Without sufficient and consistent air supply, air orbital sanders will not perform to expectations. In fact, this common problem may be the culprit if your shop is experiencing an unacceptable level of swirl marks on wood-product surfaces. Workers too often blame abrasives for surface problems when, in fact, a compressor malfunction is at fault.

Lack of air supply on sanders may be the result of an air compressor’s size or placement. A small compressor may lack the capacity necessary to ensure proper compression. But even more problems may occur when a compressor is located too far away from the work area. For example, distance may cause a unit to lose pressure, which may result in erratic performance of your air orbital sander. If this is the case, check the connecting hose for flaws and test its fittings for airtight connections.

Also, your sander may experience problems if too many attachments have been applied, or too many other machines are drawing from the same compressor.

Rule 2: Match PSI settings to strength of backings and grits
Wide belt sander PSI settings should change as backings and grits change. Otherwise, abrasives will wear out quickly, which will result in more time-consuming change-outs than are necessary.

Abrasive technicians agree that observing one basic rule should keep a shop productive and efficient: The more pressure you must apply to a product surface, the heavier the backing and the coarser the grit should be. Conversely, less pressure means using settings at the other end of the spectrum.

Also, for the best results, observe recommended PSI settings: paper belts (45-55 PSI); cloth belts (55-65 PSI); and polyester belts (65-75 PSI).

Rule 3: Let the sander do the work
Applying too much pressure on equipment may induce or aggravate repetitive motion issues: carpal tunnel syndrome occurs when the median nerve, which runs from the forearm into the hand, becomes pressed or squeezed at the wrist. Too much pressure also causes excessive wear on the equipment and premature sandpaper wear.

A worker who is applying too much pressure may think he is accomplishing more work at a faster rate, but most likely the opposite is true. The equipment has a job to do. For best results, operators need only provide direction and control — not muscle.